Even after a minor accident srs airbag module will register crash data codes into its memory. Which will make the airbag light illuminate on your dashboard.

Airbag SRS control modules are also known as"sdm", "sensor", "computer", "derm" and "brain." 

Almost all 1996-2018 airbag modules can be reset and reprogrammed, except if flood, fire or hardware damaged.

It is always best to send your original module to us for reset to avoid additional trip to the dealer for coding. Most of the late model cars will have partial VIN stored in the airbag control module.

If vehicle had one or more AirBags deployed and/or Seatbelt(s) locked up, those must be repaired first, before Installing Repaired AirBag Module into the vehicle!

SRS Airbag Module Removal & Installation Procedure:

Removing SRS AirBag Computer Module: 

1. Disconnect battery negative than positive terminal.
2. Remove SRS airbag module.

Installing SRS AirBag Computer Module:

1. Disconnect battery negative first than positive terminal.
2. Install and connect SRS airbag module. (make sure to install all grounding screws!)
3. Reconnect battery. Turn switch to "accessory".
4. Wait few seconds until the SRS light stops flashing.
5. Turn off the key. (SRS Airbag Module is now correctly installed) 

• Never probe the electrical connectors on air bag or seat belt.
• Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
• Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
• Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.